OTHER INFORMATION
USER GUIDE
The
Cuprinol Power Sprayer
is not intended for use with any other treatment, either water-based or solvent-based and is not to be used with solvent based
wood preservers, creosote or creosote alternatives. It is not intended to be used with any agrochemicals (insecticides, fungicides, herbicides) or any application
other than the recommended treatments.
It must under no circumstances be used with flammable fluids.
Using the
Cuprinol Power Sprayer
for application
of products other than those listed above could damage it and will invalidate the guarantee. This guarantee does not affect your statutory rights.
Thank you for purchasing the
Cuprinol Power Sprayer
. Please read all the instructions
in this user guide before using this product and retain them for future use.
CAUTION: DO NOT LEAVE SPRAYER FILLED WITH
PRODUCT OR WATER WHEN NOT IN USE OR OVERNIGHT.
REMOVE BATTERY BEFORE CLEANING.
CLEAN WITH WATER ONLY, DO NOT USE WHITE SPIRIT
OR OTHER SOLVENTS.
NOZZLE: Remove nozzle retainer and wash
thoroughly all nozzle components including the
nozzle filter (4) under running water using a soft
nail brush to remove any product. Check to see
if nozzle holes are clear of any product. Do not use
wire, pins or similar sharp objects to clean or unblock
the nozzle. This will lead to damage and a poor
spray pattern. Do not allow product to dry as this
will block nozzle components. Remove nozzle
elbow (5) and clean thoroughly under running water.
TANK: Remove tank from pump body by releasing
lock button (22)(see Fig 2). Pour any remaining
product back into the original pack. Rinse out tank
throughly and wipe off any product from the base
and the main pump body with a cloth.
INNER PIPES: Fill the now clean sprayer tank with
5 litres of water and reattach to the pump body.
Do not replace nozzle elbow and nozzle
components back on the lance during this operation.
Switch on the
Power Sprayer
and allow the liquid
to flow through into an empty container and then
flush down a sink. Do not dispose of washings into
drains or watercourses. Continue pumping water
until the waste water runs clear (this might take
3-5 minutes) refilling the sprayer tank with clean
water if necessary.
SUCTION PIPE AND INLET FILTER: Remove suction
pipe and inlet filter (25-29) and clean under running
water with a soft brush to ensure all product is
removed especially from the inlet filter (29).
To avoid losing smaller components we recommend
storing the
Power Sprayer
fully assembled.
Reassemble the nozzle and attach to the nozzle
elbow and lance before storing.
J
STORAGE
CAUTION: ENSURE SPRAYER IS
THOROUGHLY
CLEANED AND DRY BEFORE STORAGE.
The
Cuprinol Power Sprayer
has been designed
to operate with minimum maintenance.
Continuous satisfactory operation depends upon
proper care and cleaning after use.
Retain this user guide for future reference
(new copy may be downloaded from
www.cuprinol.co.uk)
Store the
Power Sprayer
and charger in dry
conditions. Do not store the Power Sprayer with
any remaining water in the pump or in extreme
temperatures.
CLEANING AND STORAGE
TM
The Cuprinol Power Sprayer has been specially designed for use with Cuprinol Sprayable Plus
5 Year Fence Treatment, Cuprinol Sprayable Fence Treatment, Cuprinol Sprayable Decking Treatment,
Cuprinol Total Garden Wood Treatment and Cuprinol Garden Shades.
Visit our website
www.cuprinol.co.uk
for a useful step by step
product demonstration
Fig 2
I
CLEANING
J
STORAGE
CHARGERS
Only use the rechargeable battery with the charger as supplied.
Never attempt to recharge non rechargeable batteries. Do not
expose to water. Do not open the charger.
BATTERIES
Do not attempt to open the battery for any reason. Under extreme
conditions, battery leakage may occur. If you notice liquid on the
battery wipe off using a cloth avoiding skin and eye contact.
Do not re-use battery. Do not incinerate battery. Fire hazard! Do not
short circuit contacts of a detached battery for any reason.
Dispose of batteries at your local recycling centre.
Do not store the battery in any location where
temperatures may exceed 40ºC. Only charge
the battery at ambient temperatures of between
4ºC and 40ºC using the charger provided.
1 YEAR GUARANTEE
The guarantee is valid for 1 year from date of purchase and covers
the complete
Cuprinol Power Sprayer
.
We will repair the
Cuprinol Power Sprayer
or replace free of charge
if it is faulty due to a manufacturing or material fault.
The guarantee does not cover the application of the
Cuprinol
Fence
Treatment, Decking Treatment, Total Garden Wood Treatment and
Garden Shades. The following are specifically excluded from the
terms and conditions of this guarantee:
• Damage caused by misuse or improper handling of the
Cuprinol
Power Sprayer
or not used in accordance with the instructions.
• Normal “wear and tear”
• Damage suffered through negligence, wilful damage, improper
use or accidental damage.
• Any modifications made by the purchaser to the
Cuprinol Power
Sprayer
or repairs carried out by an unauthorised service agent.
• Damage caused by immersion in water, damp, fire, natural light
and atmospheric conditions.
This guarantee does not affect your statutory rights.
TO MAKE A CLAIM UNDER THE GUARANTEE
Return the sprayer to the store where purchased together with proof
of purchase, or call the ICI Customer Advice Centre for further details.
If returning the
Cuprinol Power Sprayer
, use the original packaging
or a similar box to prevent further damage.
FOR TECHNICAL PRODUCT ADVICE CONTACT:
The Customer Advice Centre
ICI Paints, Wexham Road, Slough, SL2 5DS
Telephone 0870 444 1111
www.cuprinol.co.uk
FOR REPUBLIC OF IRELAND:
Dulux Paints (Ireland) Ltd,
Commons Road, PO Box 45, Cork
Tel353 (0)21 422 0222
Cuprinol
, the tree device,
Cuprinol Power Sprayer
,
Garden Shades
,
Cuprinol
Total
and the distinctive livery are trade marks of Imperial Chemical Industries
Plc. © ICI 2006 (11/06)
