Cupra BORN, Руководство пользователя

Страница: 283 / 343

Checking and refilling levels
282
WARNING
For your own safety, do not ignore this im-
portant check list, otherwise this could cause
accidents and serious injuries.
• Always follow the indications on the check
list and always bear in mind the general
safety measures.
Opening and closing the front bon-
net
Fig. 189 Release lever in the driver's
footwell area.
Fig. 190 Lever under the bonnet.
Open the front bonnet
The front bonnet is released from inside.
Before opening the bonnet, make sure that the
windscreen wiper arms are in place against the
windscreen.
• Open the door and pull the lever that is un-
derneath the instrument panel
›››
Fig. 189
1
.
•
To lift the bonnet, press towards the left on
the lever located under the bonnet, in the cen-
tre
›››
Fig. 190
2
. The fastening hooks are
unlocked.
• The bonnet can be opened. Release the
bonnet stay and secure it in the fixture de-
signed for this in the bonnet.
Closing the front bonnet
• Slightly lift the bonnet.
•
Release the bonnet stay and replace it in its
support.
•
At a height of approximately 20 cm let it fall
so it locks.
If the bonnet does not close, do not press
downwards. Open it again and let it fall as men-
tioned above.
WARNING
Make sure that the bonnet is properly closed.
If it opens when driving, it can cause an acci-
dent.
NOTICE
To avoid damage to the bonnet and to the
windscreen wiper arms, only open it when
the windscreen wipers are in place against
the windscreen.
Fluids and consumables
Introduction
All fluids and consumables, such as engine
coolant or vehicle batteries, are subject to
continuous development. For this reason,
whenever a fluid or consumable needs to be