Cupra BORN, Руководство пользователя

Страница: 264 / 343

Storing objects Luggage compartment equipment
263
NOTICE
Incorrect use of the second luggage com-
partment floor can cause damage to it or the
luggage compartment trim.
• When closing the second luggage com-
partment floor, always guide it carefully
downwards without dropping it.
• As far as possible, always spread the load
(maximum 50kg) over the entire surface
of the luggage compartment floor to avoid
overloading any one spot.
Luggage compartment
equipment
Fastening rings
Fig. 173 In the luggage compartment:
fastening rings.
There are fastening rings
›››
Fig. 173 on the
front and rear of the boot to secure loose
objects and luggage with fastening belts and
cords.
WARNING
If unsuitable or damaged belts or retaining
straps are used, they could break in the event
of braking or an accident. Objects could then
be launched across the passenger compart-
ment and cause serious or fatal injuries.
• Always use belts or straps that are suitable
and in good condition.
•
Tighten the belts and straps in a cross lay-
out over the load placed on the boot floor
and secure them to the fastening rings safely.
•
Never exceed the maximum tensile load of
the fastening rings when securing objects.
• Make sure that, particularly for flat objects,
the upper edge of the load is higher than the
fastening rings.
• Depending on the features, take into ac-
count the instruction panels on the boot on
how to place the load.
•
Never secure a child seat to the fastening
rings.
Note
• The maximum tensile load that the fasten-
ing rings can support is approx. 3.5 kN.
•
Belts, straps and securing systems for the
appropriate load can be obtained from spe-
cialised dealerships. To do so, CUPRA recom-
mends going to a specialised CUPRA dealer
or any SEAT dealership.
Bag hooks
Fig. 174 In the boot: retaining hooks.
There may be hooks for hanging bags on
both sides of the luggage compartment
›››
Fig. 174 .
The retaining hooks have been designed to se-
cure light shopping bags.