Cupra BORN, Руководство пользователя

Страница: 122 / 343

Visibility Windscreen wiper and rear window wiper systems
121
0
1
A
Note
• When the vehicle stops while the wiper is
on, the wiper switches to operating tempora-
rily at the next lower wiping level.
•
If the driver’s or passenger door is opened
when the vehicle is stationary, the wipers re-
turn to the starting position and are switched
off. If the door is closed or the wiper lever is
moved within a few seconds, the wiper turns
on again.
• In winter, the service position of the wipers
can be useful to make it easier to lift the wip-
ers off the windscreen when the vehicle is
going to be left stationary
›››
page 267
.
Wiper functions
Automatic rear window wipe
The rear wiper switches on automatically when
the wiper is switched on and reverse gear is en-
gaged. The automatic rear window wiper acti-
vation when engaging reverse gear can be acti-
vated and deactivated in the infotainment sys-
tem, in the vehicle settings menu
›››
page 36 .
Heated windscreen washer nozzles
The heating defrosts any windscreen washer
nozzles that have frozen. The heat output is
automatically adjusted according to the ambi-
ent temperature when the ignition is switched
on. The heater only defrosts the nozzles,
but not the flexible pipes through which the
washer fluid passes.
Rain and light sensor
Fig. 111 Windscreen wipers lever: adjust
the rain sensor
A
.
Fig. 112 Rain sensor sensitive surface
The rain sensor controls the frequency of the
windscreen wiper intervals, depending on the
amount of rain
›››
.
Push the lever to the desired position
›››
Fig. 111 .
Rain sensor off.
Rain sensor on; automatic wipe if neces-
sary.
Setting sensitivity level of rain sensor:
– Set control to the right: high sensitivity.
– Set control to the left: low sensitivity.
Automatic wiping can be activated and deacti-
vated in the vehicle settings menu of the info-
tainment system
›››
page 36 .
When automatic scanning is deactivated in the
infotainment system, the duration of the inter-
vals is set in fixed levels.
Abnormal operation of the rain and light
sensor
The possible causes of anomalies and errone-
ous interpretations
in the sensitive surface area
›››
Fig. 112 of the rain sensor are, among oth-
ers:
• Damaged wipers : a film of water on the
damaged blades may lengthen the activation
time, reduce the washing intervals or result in a
fast and continuous wipe.
• Insects : the impact of insects may cause the
wiper to activate.