Installation
11
Cat. No. 01024821
Drain Line Flow Control Replacement
Refer to
, Figure 8, and the instructions below to replace the drain line flow control.
1. Remove the cover by releasing the cover fastener from the control valve. See Figure 6 and Figure 7.
2. Remove the drain clip and pull off the drain elbow.
3. Remove the backwash flow control located behind the elbow.
4. Install the correct drain line flow control.
5. Reverse the procedure to reassemble.
NOTE The number on the flow control should face into the valve body.
NOTE Do not re-install the cover until the drain line tubing is connected.
Figure 6. HE 1.5 Twin valve cover fastener clip.
Figure 7. Removing the HE 1.5 Twin valve cover.
Figure 8. Replacing backwash flow control.
Clips
Flow Control
Drain Elbow
Brine Connector
