figure 28
figure 27
figure 29
19
Cleaning the K-Cup
®
Holder
1. The K-Cup
®
holder is top-shelf
dishwasher safe (use low temperature
cycles in the dishwasher). To remove, lift
the handle to open the brewing
chamber. Grasp the top of the K-Cup
®
holder and pull towards you. After
cleaning, replace the K-Cup
®
holder,
being sure to align the arrow on the
K-Cup
®
holder rim with the arrow on the
brewing chamber.
2. Cleaning the Funnel – The Funnel can be
removed from the K-Cup Holder by
pulling on it until it pops off (see figure
27). The Funnel is top-rack dishwasher
safe. To replace it, just snap it back onto
the K-Cup Holder Assembly.
3. Cleaning the Exit Needle – The Exit
Needle is located on the inside bottom
of the K-Cup Holder Assembly. Should a
clog arise due to coffee grinds, it can be
cleaned using a paper clip or similar tool.
Remove K-Cup Holder (as shown in
figure 27). Insert the paper clip (see figure
28) to loosen the clog and push it out.
CaUtion:
There are sharp needles
that puncture the K-Cup above and
below. To avoid risk of injury, do not put
your fingers in the K-Cup Assembly
Housing.
Cleaning the Water reservoir
& Lid
Neither the reservoir lid nor the reservoir
should be put into the dishwasher. Clean
them with a damp, soapy, non-abrasive
cloth and rinse thoroughly. Do not dry the
inside of the water reservoir with a cloth, as
lint may remain.
Caution: rinse the water reservoir
thoroughly after cleaning to ensure
that no cleaners or cleaning
solutions remain in this area, as they
may contaminate the Brewer’s
water supply.
Содержание SS-780PC
Страница 23: ...23 NOTES...