5
3. With both units in an upright position, lift
up the left-side unit slightly, placing the
two legs into the connectors on the
right-side unit.
4. Align the left-side unit and the right-side
unit so they are as close together as
possible. To secure the units into position,
turn both front and rear legs of the
left-side unit counterclockwise until tight.
5. Take connecting plug from back of the
left-side unit and plug into back socket of
the right-side unit.
6. Plug the power cord from the right-side
unit. into a standard electrical outlet and
the unit will turn on automatically.
ALWAYS REMOVE ALL WINE BOTTLES
BEFORE MOVING THE WINE CELLAR.
LEVELING YOUR WINE CELLAR
Each wine cellar has 4 leveling legs. After
properly placing your wine cellar in its final
position, you can level it. (Please note that
the leg that stands on hinges is the shorter
leg.) Leveling legs can be adjusted by
turning them clockwise to raise the wine
cellar, or by turning them counterclockwise
to lower the cellar.
INSTALLATION LIMITATIONS
Do not place heavy objects on top of the
unit. Do not place the unit in a moist area
or in direct sunlight.
Do not place the unit next to a major
appliance that emits large amounts of heat,
such as a dishwasher, microwave, toaster
oven, oven or barbecue, etc.
Do not install your wine cellar in any location
not properly insulated or heated (garage,
etc). Select a suitable location for the wine
cellar on a hard, level and even surface,
away from direct sunlight or heat source,
e.g., radiators, baseboard heaters, cooking
appliances, etc. Any surface unevenness
should be corrected with the leveling legs
located on the front and rear bottom corners
of the wine cellar. Avoid placing unit where
there may be electrical interference.
NOTE:
To minimize the risk of rusting,
leakage and insulation damage, avoid
placing the unit where heavy moisture is
present. Under no circumstances spill or
directly apply water onto or into the unit.
PROPER AIR CIRCULATION
To assure that your wine cellar works at the
maximum efficiency for which it was de-
signed, you should install it in a location
where there is proper air circulation and
electrical connections.
NOTE: The wine cellar is designed for
freestanding operation. It is not made to
be recessed or built-in (fully recessed).
CONTROL PANEL FOR EACH UNIT
