PROGRAMMING YOUR
COFFEEMAKER
1. Setting the Clock
When the coffeemaker is plugged in, 12:00 will
appear until you set the time.
Entering “Time Set” Mode:
To set the time, hold down either the “Hours” or
“Minutes” button until the clock begins flashing
(about 2 seconds). You are now in the “Time
Set” mode and can operate either button to
achieve the desired setting. The buttons can
be held down to scroll through the digits, or
pressed and released lightly to advance one
digit at a time.
When scrolling, the numbers will advance
slowly at first and then speed up to the rate
of about three per second. When the number
displayed approaches the desired setting,
release the button and press repeatedly to
advance one digit at a time. Be careful to make
sure that the PM indicator is on if a
PM time is desired.
Exiting “Time Set” Mode:
The “Time Set” mode can be exited in
one of two ways:
1. Press any button besides the “Hours” or
“Minutes” button. This will exit the “Time Set”
and activate the selected function.
2. Do nothing. If neither the “Hours” nor
“Minutes” button is pressed for a period
of five seconds, the “Time Set” mode will
be exited.
2. Setting the Program Time:
When you press the “Program Set” button,
it displays the current program time
(default time 12:00 p.m.).
Entering “Set Program Time” Mode:
Press and hold the “Program Set” button (about
2 seconds) until the green light and LCD display
begin to flash. This signals that you have entered
the “Set Program Time” mode. The desired time
can be set by pressing the “Hours” and “Minutes”
buttons to scroll forward through the digits.
Pressing and holding either button will allow you
to scroll continuously, slowly at first, and then to
accelerate to the rate of about three digits per
second. As the desired time setting approaches,
release the button and then press repeatedly to
advance one digit at a time. The coffeemaker
will start to brew at the programmed time.
The “Program” mode cannot be entered if the
coffeemaker is in its “brew” or “keep warm” cycle.
Exiting “Set Program Time” Mode:
“Set Program Time” may be exited in any
of three ways:
1. Press the “Program Set” button. This will
cause the coffeemaker to revert to its
previous state. If it was OFF, it will return
to the OFF position. If “Programmed”,
it will revert to this state, and so on.
This is a safety feature.
2. Press any other button (except “Hours”
or “Minutes”). “Set Program Time” will be
exited and the function of that button will
be executed.
3. Do nothing. If neither the “Hours” nor
“Minutes” button is pressed for a period of
five seconds, the “Set Program Time” mode
will be exited and the programmed setting
will be in effect.
PROGRAMMING AUTOMATIC
SHUTOFF TIME
The Automatic Shutoff Time can be programmed
anywhere from immediate shutoff after
completion of the brew cycle up to four hours.
When the coffeemaker shuts itself off, two tones
will sound. Two hours is the default time. The
0:00 setting shuts the unit off immediately after
brewing is complete. To check the current
setting, press and hold the “On/Off” button and
the Automatic Shutoff Time will be displayed.
To change the preset time, press and hold
the “On/Off” button until the red “power”
light and LCD display begin to flash.
This signals that you have entered the
“Set Automatic Shutoff” mode.
Press the “Hours” and “Minutes” buttons
to scroll forward through the digits until
desired time appears. The first setting which
appears is preset at “2:00”. When it’s at “4:00”,
the next press key of “hour” will roll back to
“0:00”, since four hours is the maximum
Automatic Shutoff setting. Pressing and
8
02CC18081 DGB500C IB - E 9/11/02 9:50 AM Page 10
