6
OPERATING INSTRUCTIONS
1. Always use the appliance on a dry, level
work surface then place the work bowl on
top of the housing unit with the handle just
to the right-of center then turn clockwise to
lock it onto the housing base.
2. Carefully lift and place the blade or desired
slicing disk (blade facing up) over the work
bowl accessory-adapter. Blade or disk
should fit comfortably and rest on the
bottom of the work bowl.
3. Place lid on work bowl, with the feed tube
just to the right of the center. Turn
clockwise to lock onto work bowl.
4. Align pusher with the feed tube opening
on the lid and slide down to the bottom
5. Plug in the housing base and add desired
ingredients to work bowl.
6. Add ingredients to the work bowl, either
through the feed tube or directly into the
work bowl.
7. Press the High or Low button to start the
unit – the blue LED light will illuminate and
the motor will run until Off is selected.
8. Alternatively press the Pulse button to
provide more accurate control of the
duration and frequency of processing.
Unless otherwise specified, a pulse should
be about one second. Press the Pulse
button repeatedly as needed.
CLEANING &
MAINTENANCE
• When not in use, leave unplugged.
• Keep the blade and discs out of the reach of
children.
• All parts except the housing base are
dishwasher safe and recommend washing
them in the dishwasher on the top rack only.
Due to intense water heat, washing the work
bowl, cover and accessories on the bottom
rack may cause damage over time. Insert the
cover with the feed tube facing up to ensure
proper cleaning. Insert the work bowl and
pusher upside down for drainage. Remember
to unload the dishwasher carefully wherever
you have placed sharp blades and discs.
• To simplify cleaning, rinse the work bowl,
cover, pusher and blade/disc immediately
after use so food won't dry on them. If food
lodges in the pusher, remove it by running
water through it, or use a bottle brush.
• If you wash the blade and discs by hand, do
so carefully. When handling, use the plastic
hubs. Avoid leaving them in sudsy water
where they may disappear from sight. To
clean the metal blade, fill the work bowl with
sudsy water, hold the blade by its plastic
center and move it rapidly up and down on
the center shaft of the bowl. Use of a spray
attachment is also effective. If necessary, use
a brush.
• The work bowl is made of SAN plastic. It
should not be placed in a microwave oven.
• The housing base may be wiped clean with a
sudsy, non-abrasive cloth or sponge. Be sure
to dry it thoroughly.
• If the feet leave spots wipe the area with a
damp sponge and nonabrasive cleaning
detergent.
• IMPORTANT:
Never store any blade or disc
on the motor shaft. No blade or disc should
be placed on the shaft except when the
processor is about to be used.
• Any other servicing should be performed by
an authorised service representative.