The DLC-5 is intended for Household
Use Only
SAFETY
• Like any powerful electrical appliance, your
food processor should be handled with care.
These are some procedures that will protect
you and your family from misuse that could
cause injury.
• Handle metal blade and discs carefully. Their
cutting edges are very sharp.
• Never put blade or disc on motor shaft until
work bowl is securely locked in place.
• Always make certain that blade or disc is
down on motor shaft as far as it will go.
• Always insert metal blade in work bowl before
putting ingredients in work bowl.
• When slicing or shredding food, always use
pusher.
Never put your fingers or a spatula
into feed tube.
• Always wait for blade or disc to stop spinning
before you remove cover from work bowl.
• Be careful not to let metal blade fall out of
work bowl when you empty bowl. Remove it
before tilting bowl, or hold it in place.
SOME TECHNICAL DATA
The line voltage and frequency appropriate for
your machine are shown on label on underside
of base.
A safety switch prevents machine from operat-
ing when work bowl or cover is not locked into
position. Motor stops within seconds when
control switch is turned off or cover is
unlocked.
An automatic temperature-controlled circuit
breaker in the motor ensures protection against
motor burnout. If processor runs for exception-
ally long time when chopping, mixing or knead-
ing thick or heavy mixtures in successive
batches, motor may overheat. If this happens,
processor will stop. Turn it off and wait for
motor to cool off before proceeding. It will usu-
ally cool off within 10 minutes. In extreme
cases, it could take an hour.
If it does not start or stop, please call our
Customer Service Department toll free at 800-
726-0190.
REPACKING
FOR SHIPMENT
Save the carton that your food processor was
packed in, and the carton inserts too. They will
be useful if you need to repack the processor
for moving or other shipment.
1. Open 4 flaps at one end of carton.
Insert plastic foam block with cut-out for
processor base at closed end of carton.
2. Place carton on floor or low table.
3. Place work bowl on base of machine and
lock it into place. Coil power cord and
secure it with rubber band or twist tie.
Make sure work bowl is still locked into
place.
4. Lift base by grasping top of work bowl with
both hands. Lower it into box, positioning it
so control switch and power cord fit into
appropriate cutouts of foam block.
5. Insert metal blade on motor shaft.
6. Place second foam block into carton, posi-
tioning it so short side with cavity for work
bowl cover goes over handle side of work
bowl.
7. Slide slicing and shredding discs into slots
provided on opposite long sides of foam
block. BE CAREFUL NOT TO TOUCH
CUTTING EDGES.
8. Insert spatula, round side up, into space
provided on one long side of foam block.
9. Insert work bowl cover, upside down, into
large cavity of foam block.
10. Insert pusher into feed tube of workbowl.
11. Close flaps and tape all seams securely
with pressure-sensitive or other packing
tape. If you are shipping by public carrier,
wrap carton in heavy paper, tape or tie it
and address it. The Cuisinart Customer
Service Department will give you complete
shipping instructions if you are returning
processor for repair.
12
03CU13009 DLC-5 IB REV vert 6/23/03 1:55 PM Page 13