12
13
WarninG!
Never attempt to use damaged or obstructed equipment. See your local Liquid Propane dealer for repair.
DISCONNECTING THE LIQUID PROPANE CYLINDER
Turn the smoker burner valves “OFF” and make sure the smoker
is cool. Turn the Liquid Propane cylinder valve “OFF” by turning clockwise until it stops. Detach the regulator assem-
bly from the cylinder valve by turning the quick coupling nut counterclockwise. Place dust cap on cylinder valve outlet
whenever the cylinder is not in use. Only install the type of dust cap on the cylinder valve outlet that is provided with the
cylinder valve. Other types of caps or plugs may result in leakage of propane.
5.3 Checking for Gas Leak
LEAK TESTING GENERAL:
Although gas connections on the smoker are leak tested prior to shipment, a complete leak
test must be performed at the installation site. Before each use, check all gas connections for leaks using the procedures
listed below. If the smell of gas is detected at any time, you should immediately check the entire system for leaks.
BEFORE TESTING:
Make sure all packing materials have been removed from the smoker
Make a solution of one part liquid detergent and one part water. You will need a spray bottle, brush, or rag to apply the
solution to the fittings. For the initial leak test, make sure the Liquid Propane cylinder is full.
TO TEST
1. Turn the burner valves off.
2. Turn the Liquid Propane cylinder valve counterclockwise to open the valve.
3. Apply the soap solution to all gas fittings. Soap bubbles will appear where a leak is present.
4. If a leak is present, immediately turn the gas supply “OFF” and tighten leaky fittings.
5. Turn the gas back “ON” and recheck.
6. Should the gas continue to leak from any of the fittings, turn the gas supply “OFF” and contact customer service at
866-994-6390 or email [email protected]
7. If there is evidence of excessive abrasion or wear, or the hose is cut, it must be replaced prior to the outdoor
cooking gas appliance being put into operation. Only those parts recommended by the manufacturer should be
used on the smoker. Substitutions will void the warranty.
WarninG!
Do not store smoker indoors unless the cylinder is disconnected. Do not store cylinder in a building, garage, or any other
enclosed area, and keep area, and keep out of reach of children at all times.
INSTALLER FINAL CHECK
Maintain specified clearance of 36 inches from combustible materials and construction.
• All internal packaging has been removed.
• The hose and regulator are properly connected to the Liquid Propane cylinder.
• The unit has been tested and is free of leaks.
• The gas supply shutoff valve has been located.
• All burners are installed.
• Keep the instruction manual for future reference
5.4 Lighting the Smoker
1. Make sure the propane cylinder is tightly threaded into the regulator (hand tighten only).
2. Open bottom door. Always open bottom door when lighting.
3. Push and turn control knob slowly counterclockwise to IGNITE/HI. Burner should light immediately.
4. If ignition does not occur in 3-5 seconds, turn the control knob “OFF”. Wait 5 minutes before attempting to re-light
the smoker. If the smoker fails to ignite after the third attempt, call customer service at 1-866-994-6390 for assis-
tance. With burner lit, gently close the bottom door and allow the smoker to warm up for prior to use.
Note: If the knob can’t spark, insert a match into the match holder. Ignite the match and insert though the opening in the
bottom door toward the burner.
TURNING THE SMOKER OFF
1. Turn knob to “OFF” position.
2. Turn the propane cylinder control knob to the “OFF” position. Caution: Do not attempt to re-light the smoker with-
out following all the lighting instructions.
3. Allow the smoker body to cool at least 30 minutes before attempting to move or transport.
5.5 Match lighting
imPortant!
1.Read all instructions before lighting.
2. Make sure the gas control knob is in “OFF” position.
3. Open doors during lighting.
4. Strike a long wooden match and position the burning match to the burner box. Place the flame near the bottom
edge of the burner.
5. Push down and turn the control knob counterclockwise to the high setting.
6. The burner should light. The flame will carry around the burner.
m
caUtion:
Do not touch any hot smoker parts. The outside of the smoker bottom especially becomes very hot during use. Use
protective gloves to handle any parts that might become hot during use.
5.6 Using the Smoker
• Add wood chips to bowl portion (inner ring) of water/wood chip bowl. If you presoak wood chips for 30 minutes in
water, drain, and then add to wood chip bowl, wood chips will last longer before burning up
• Fill the rest of the tray with water-this will add moisture to the air to keep food from drying out. Water also helps
maintain a consistent air temperature. Add juice, beer, or vinegar to the water bowl to add additional flavor to whatever
you’re smoking as the liquid evaporates
• Follow lighting instructions to light smoker
• Close smoker doors and let smoker heat to desired temperature before adding food
• Wood chips are necessary to provide smoke
• Keep doors closed at all times except when adding wood chips or water or adding/removing/checking on food.
Opening doors will lose smoke and heat and can cause the wood to flare up
• Adjust control knob and air vent to control temperature (if temperature is getting too high even after making
adjustments-add more water to water tray)
• Open lower door to slide water/wood chip bowl out to refill
• Clean out wood chip bowl after each use to prevent ash buildup
• It is normal for smoke to quickly create a brown/black buildup along the inside of the smoker
5. operating Your Smoker (cont.)
