10
Food Processor button the desired number of times. Motor runs as
long as you hold the Food Processor button down. The motor stops
when you release control switch. Try it a few times.
You control the duration and frequency of pulses by the length of
time you hold the Food Processor button down and the rate at
which you press it. Pulses should be short bursts. Allow enough
time between pulses to let food in work bowl fall to bottom.
Always use the Food Processor button for pulse/chopping.
Never turn cover back and forth to start and stop processor.
USING THE POWERBLEND DUET
™
BLENDER/FOOD
PROCESSOR TO CHOP, PURÉE, AND MIX
Refer to Food Processor Assembly instructions on pages 8–9.
1. Cut food into ¾" pieces. You will get a more even chop if you
start with pieces that are all the same size. Put pieces into work
bowl with metal blade in place. You can put in up to 1 cup of
food at a time. If you want to process more, do it in batches.
. Put on cover, lock it and insert pusher. It is recommended that
one hand be placed on the food processor lid while in use, to
provide unit stability. Press the On button, press the Pulse
button, and the Food Processor button (to pulse), then release.
Repeat two to three times. Each time blade stops, let food pieces
drop to the bottom of bowl before pulsing again. This ensures
that the blade will chop them at every pulse. Watch what happens
to the food. With pulse/chopping technique, you can get an even
chop without danger of overprocessing. Check texture
by looking through work bowl. Be careful not to overprocess.
For a coarse chop, pulse only a few times.
3. If you want a finer chop or purée, press the On button and then
the Food Processor button and let machine run continuously
until the food is chopped as fine as you want it. Check frequently
through clear cover or bowl to avoid chopping too fine. Use a
plastic spatula to scrape down any pieces that stick to inside
of bowl.
Onions and other food with a high water content turn into a smooth
purée very quickly. Do not overchop – look at food frequently
through work bowl.
To purée, follow same procedure as for chopping, but let machine
run until food is a smooth purée.
New users are often surprised at how fast the processor works. You
will quickly get used to its great speed.
These are some conditions that affect your results:
• Size of pieces you put in bowl – all should be about the same size.
• Amount of food you process – don’t add too much.
• Type of processing you choose – continuous or pulse/chopping.
ADDING FOOD WHILE PROCESSING
To add liquid while the machine is running, pour it through the
open feed tube. This is especially useful when making mayonnaise
or dressings.
A small hole in the pusher allows you to add liquids in a very slow,
steady stream – useful when making sauces.
When you want to add small pieces of food like cheese, meat or
garlic cloves while machine is running, drop them through open
feed tube.
To prevent spills when adding sugar and other dry ingredients,
use a funnel.
REMOVING PROCESSED FOOD
Before removing processed food, press Off button and wait for
blade to stop spinning. Then remove cover by turning it
counterclockwise. Never try to remove cover and work bowl
together; this can damage work bowl.
It is important not to let metal blade fall out of work bowl as you
empty it.
Here are two ways to prevent it from falling
out:
1. Before tilting bowl, use spatula to remove
food from around blade. Carefully remove
blade by the plastic hub.
. Hold top of blade in place with finger or
spatula while pouring out processed food.
At this point, you may either lift the work bowl
off motor base, or hold the collar at the base and turn the handle of
the bowl counterclockwise and lift blade straight up.
NOTES:
Occasionally, a piece of food may become wedged
between the blade and the work bowl. If this happens, remove the