ADJUSTING THE SHIPPING BOLTS
PLACEMENT AND LEVELING
1 Carefully tip the Cubiscan 110-T onto the back panel to expose the bottom of the scale.
2 Use a 13 mm open-ended wrench to turn all three of the shipping bolts clockwise until
the head is tight against the scale plate.
2 Place the bubble level provided in the center of the scale platter.
3 Adjust the five leveling feet under the Cubiscan 110-T to level the scale. Make sure all
feet are touching the supporting surface.
3 Tip the Cubiscan 110-T back to its upright position.
3 Use the screws from step 1 to secure the back panel in its upright position.
4 Insert the plug on each length sensor cable into its socket on the back (at each
end) of the Cubiscan 110-T.
5 Route the height sensor cable up the channel on the back panel, and insert the
plug into the socket on the height sensor.
1 Place the Cubiscan 110-T on a solid, stable surface. Be sure that nothing touches the
back wall or top platter, as this may affect the scale.
Before
Shipping bolts
After
V 11/14/17
Copyright© 2018 by Quantronix, Inc.
All rights reserved.
