CUBICON Style Plus-A15 Series
User Manual
Cautions for the Use
Before using the printer, read ‘Cautions for the Use’ as mandatory, and follow the instructions.
Filament
Use a genuine filament that is sold by our company.
* The breakdown that occurs during the use of a non-genuine filament would not be covered by
free warranty.
Use the filament that has been opened as fast as possible.
If it is inevitable to be stored, the filament shall be fixed to the spool so that it wouldn’t get
loosened, and stored after it is sealed.
Be cautious not to damage/separate NFC TAG that is attached on the spool
Mounting and
Unmounting the
Filament Spool
After mounting it while paying attention to the rotation direction of the filament and the direction
of NFC tag, check the locking status of the door.
When unmounting the filament spool from the printer, be cautious not to let the filament get
loosened from the spool.
Filament Replacement
Loading
Be cautious about the configuration of the extruder temperature
* If the temperature is not properly set up, the extruder would break down due to the clogging of
the nozzle or cracking of the filament.
Be cautious about the temperature setting and sufficiently remove the previous filament in the
inside of the nozzle when replacing it with new filament.
Temperature
Condition for the
Nozzle and the
Heating Bed
Use it by heating the nozzle/the heating bed to the temperature that is appropriate for the
filament that is used.
If the temperature of the filament that is used is not in a proper range, poor printing quality and
device failure such as a carbonization of the filament, improper extruding, cracking, a gap on
the base may occur.
The sculpture that the printing has been completed must be separated after the heating bed
cools down sufficiently.
Cleaning of the
Removable Extruder
Nozzle
It is necessary to regularly check the extrusion status and clean the nozzle.
* Replacement of the nozzle that has been worn out in a usual condition of the use is not
covered by a free warranty.
As for the cleaning of the outer part of the nozzle, clean it with pure cotton cloth after heating
up the nozzle.
Repetition of cooling and heating of the nozzle while the filament is inside of it is prohibited.
Assemble/Disassembl
y of the Removable
Extruder
Assembly/disassembly must be performed only when the power is turned off (Power OFF).
Do not shut off the power while the removable extruder is heated.
(The case that the removable extruder is separated immediately after the power is turned off for
the repair/replacement is allowed.)
10