Cub EXPLORER, Инструкция по эксплуатации, Страница: 15 / 25

Page 15 of 25
RE-SETTING THE TENT
1. Ensure the camper is set reasonably even/level.
2. Affix all external press studs/shock cords on the trailer tent to the trailer body.
3. Ensure the door slide bar is in the down position.
4. Roll up the rear external window cover (if weather permits).
5. Release the Velcro fixing on the roll-up side wall (if your trailer has one).
6. Release the Velcro fixing on the door to the trailer floor.
7. Close the door zip or zips, if possible.
8. Release the adjusters on the front tent bow (drawbar end) and relax the tent bow fully, leave it
loose.
9. Release the centre tent bow adjusters and leave the adjusters loose.
10. Release the rear tent bow adjusters and push the tent bow outwards firmly and hold out firmly and
tighten the two adjusters.
11. Position the two corner support cup poles into the rear corners of the rear tent bow.
12. Raise the centre tent bow until the canvas prevents raising the tent bow any higher. This tent bow
should be raised equally on both sides (see how far it protrudes from the upright arms, and this
should be equal on both sides) and then tighten the adjusters.
13. Extend the front tent bow (drawbar end of the trailer) outwards, using sufficient force to square up
the side windows. The front tent wall should now be quite taut.
14. If looking better, but still requiring some adjustment, try the previous steps again, but use a little
more force on step No. 10 as this will pull more canvas from the front of the trailer to the rear.
The above steps are to return the canvas to original factory settings. If you continue to have difficulty
opening and closing the doorway zipper, please call Explorer Camper Trailer Hire on 08 8278 5771
CANVAS CARE INSTRUCTIONS