Media Installation
1. Lift open the
printer's Media Door.
Push the print head
release lever to open
the print head
mechanism
2. Move the label roll
guard horizontally to
the end of label spindle
then flip down the
label roll guard.
3. Place the roll of media
on the label supply
spindle. Push the label roll
until it is flush with the
printer side wall. Flip up
the label roll guard. Move
the label roll guard
horizontally to gently fit
the width of label roll.
4. Pull the label rolls leading edge forward over the media guide bar, under the damper,
through the media sensor placing the label’s leading edge onto the platen roller.
5. Adjust the label guide to fit the width of the label.
6.
Close the print head mechanism making sure the latches are engaged properly.
You will hear the printhead click when locked in place. You will need to apply
some downward pressure to lock the printhead mechanism.
**** For peel mode loading instructions please see the
User guide section 2.6.3 ****
Label guide