Rev. -, p. 10 of 19
11. TIGHTEN ALL BOLTS
11.1 Before and during bolt tightening, measure and
offset the side frames symmetrical to the ROPS tubing on
the rear of the tractor. Shift and/or push cab as necessary
before tightening all bolts. Tighten all bolts including
those under the floor mats, etc.. NOTE: torque the large
M12 bolts on the lower front of the ROPS tubing back to
the original equipment specifications to ensure full safety
standards.
12. AIR INTAKE SHIELD
12.1 Install the shield using two supplied hand knobs
per side (see figures 12.1). Note: hand knobs are used so
the shield is easily removable for operator access to the
battery and the front of the radiator for clean-outs.
12.2 Per figures 12.2 and 12.2.1, orient and install the
shield so the half circle relief is up top as shown.
Fig. 12.2.1 (view from right front side of tractor)
hand knobs
Fig. 12.1 (hand knobs)
Fig. 12.2 (view from rear of tractor)
relief up top
