Big Country 6 x 4 and 4 X 2 Update
2
1.10. Fold the stripped end back on itself, and crimp it
securely into the other end of the yellow butt
connector. See Figure 1.10.
1.11. Remove the accessory relay from the relay block
on the firewall. See Figure 1.11.
1.12. Remove the relay block from the firewall using a
phillips head screwdriver, and separate it from
the other two relay blocks.
NOTE:
The relay blocks have interlocking chan-
nels on each side.
1.13. Cut the white wire that enters the accessory
relay block. Leave enough length accessible on
each side of the cut to strip the insulation from
the wire and install a butt connector.
NOTE:
It may be necessary to remove some of
the protective covering (conduit) from the har-
ness.
1.14. Strip 1/4” of insulation from the ends of the two
lengths of white wire and 1/2” of insulation from
the loose end of the red wire that was previously
added to the harness connector.
1.15. Twist the two stripped ends of the white wire
together and crimp them securely into the sec-
ond yellow butt connector.
1.16. Fold the stripped end of the red wire back on
itself, and crimp it securely into the other end of
the yellow butt connector. See Figure 1.16.
1.17. Install the relay block back on the firewall, and
plug-in the relay.
1.18. Plug the voltage regulator-rectifier connector
back into the harness connector.
1.19. Connect the negative battery cable to the nega-
tive battery terminal.
1.20. Close and secure the hood.
1.21. Test-run the Big Country 6 X 4 before returning it
to service.
Figure 1.10
New red wire
Yellow butt
connector
Harness
connector
2 Original
red wires
Figure 1.11
Accessory relay
Mounting
crews
White wire
Figure 1.16
Yellow butt
connector
Red
wire
White
wires
www.mymowerparts.com
K&T Saw Shop 606-678-9623 or 606-561-4983
