Cub Cadet 7360SS, Руководство по обслуживанию

Страница: 57 / 170

56
(4)Tighten the connecting rod cap nuts in
steps to the specified torque.
(5)Check the thrust clearance for the
connecting rod big end.
9.Oil screen installation
(1)Lay the cylinder block with the bottom
(oil pan side) up.
(2)Install the oil screen in position.
The oil screen must be installed in position
so that it is below the oil level line and away
from the oil pan.
8.Connecting rod cap installation
(1)Push the piston into position until the big
end of the connecting rod is put into
position over the crankpin. Then turn the
crankshaft 180 while pushing on the top
of the piston.
(2)Install the lower halt of the connecting rod
bearing in the connecting rod cap, making
sure the tab in the back of the bearing is
in the notch of the cap.
(3)Install the bearing cap to the connecting rod.
a)Make sure the number on the cap is the
same as the number on the connecting rod.
b)In case of a new connecting rod having no
cylinder number, install the cap to the rod
with the notches on the same side.
Do not hit the piston with a hammer to install
the piston and connecting rod. This will put
force on the piston and connecting rod and
cause damage to the piston rings and crankpin.
3.55 0.25 kgf•m
(25.7 2 lbf•ft)
[34.8 2.5 N•m]
Tightening torque