Optional Kit 490-900-C066 6 of 9 Form No. 769-10822 /00
38. Make sure all air bubbles are removed from under the
label.
39. Install the steering shaft bearing over the steering
shaft. See Figure 18. Lower into position until the steer-
ing shaft bearing contacts the upper dash. See Figure 18.
40. Install the two (2) shoulder screws removed in Step
26 that secure the steering shaft bearing to the steering
bearing mounting bracket. Tighten the shoulder screws
to a torque of 68-85 in. lbs.
41. Install the dash cap. The dash cap has four (4) tabs
that lock into four holes in the top of the upper dash. See
Figure 19.
NOTE: Only the two (2) right side tabs of
the dash cap and holes of the upper dash are visible
in Figure 19.
42. Set the dash cap on top of the upper dash so that it
just hangs over the back edge as shown circled in Figure
25. This positions the four (4) tabs of the dash cap into
the four (4) holes of the upper dash shown in Figure 20.
FIGURE 17
Item #2
(777I25270)
FIGURE 18
Steering Shaft Bearing
Upper Dash
FIGURE 19
Tabs On Dash Cap
Holes In Upper Dash
Upper Dash
Dash Cap
FIGURE 20
43. While holding light pressure downward, push the
dash cap towards the engine. This will allow the four (4)
tabs of the dash cap to lock into the four (4) holes of the
upper dash.
44. Figure 21 shows the rear locking tabs of the dash cap
in relation to the upper dash prior to Step 43 and after
Step 43.
Prior To
Step 43
After Step
43
Rear Locking Tabs Of Dash Cap
Upper Dash
Rear Locking Tabs Of Dash Cap
Locked Into Upper Dash
Upper Dash
FIGURE 21