C
C
C
T
T
T
X
X
X
Service Manual
S720G
-9-
*V-Position *Adjustment
Scale
*Center *Adjustment
Scale
H-Position Adjustment
Scale
V-Position Adjustment
Scale
OSD Position
Center Adjustment
Scale
English (select)
Deatsch (select)
French (select)
Spanish (select)
Italiano (select)
Language
中文
(option)
Reset Yes/No
Source DVI/VGA
*Function is disable in DVI mode.
3.6.5 Accessory OSD Indications
Signal out of range
An input signal which is outside the range defined in
Section 3.4 shall cause the monitor to display a message
Signal Out of Range
.
No Signal Input , Input Source
“auto detecting” and power down.
When the signal cable is not plugged into PC or when the
horizontal or vertical sync are absent and when the
monitor is turned on. After 5 sec isn’t to detect H or V Sync
then show “
No Signal Input
” for 3 seconds then show”Auto
detecting” message on the OSD for 2seconds,( if first turn
on the monitor that will show it around 27 seconds.), and
then show ”
Power
down
” message on screen 2 sec.And
then the monitor shall go to power saving status.
Содержание S720G
