CTS FOS-3124 SERIES, Руководство пользователя

Страница: 24 / 223

24
Switch(config)# interface 1-3
Switch(config-if-1-3)# Enter three continuous interfaces. Use a
hyphen to signify a range of interface
numbers. In this example, interface 1, 2, and
3 will apply commands entered.
Switch(config)# interface 1,3-5
Switch(config-if-1,3-5)# Enter a single interface number together with
a range of interface numbers. Use both
commas and hypens to signify the
combination of different interface numbers.
In this example, interface 1, 3, 4, 5 will apply
commands entered.
2.6.2 No Command
Almost every command that you enter in Configuration Mode can be negated using
“no”
command followed by the original or similar command. The purpose of
“no” command is to
disable a function, remove a command, or set the setting back to the default value. In each
sub-section below, the use of no command to fulfill different purposes will be introduced.
2.6.3 Show Command
The
“show” command is very important for network administrators to get information about
the device, receive outputs to verify a command
‟s configurations or troubleshoot a network
configuration error. It can be used in Privileged or Configuration Mode. The following
describes different uses of
“show” command.
1. Display system information
Enter
“show switch-info” command in Privileged or Configuration Mode, and then the
following similar screen page will appear.