CTEK CS FREE 2005, Руководство пользователя

Страница: 19 / 19

19 CTEK SWEDEN AB
EN
• Never transport a product with power level higher than 30%.
• Dispose of the product in specific recycling boxes only after a complete discharge.
• Do not place the product in regular trash containers. Strictly follow your local regulations
regarding the disposal and recycling of product.
• Dispose of a product immediately if it cannot be powered on after over-discharging.
• The charger is only designed for charging batteries according to the technical specification.
Do not use the charger for any other purpose.
• Always follow battery manufacturers’ user and safety recommendations.
• Never try to charge non-rechargeable batteries.
• Never place the charger on top of the battery or cover the charger when charging.
• Never charge a frozen or damaged battery.
• Never use a charger with damaged cables. Ensure that the cables have not been damaged by
hot surfaces, sharp edges or in any other way.
• Never place a fan-cooled product so that dust, dirt or similar can be sucked into the fan.
• A damaged cable must be replaced by a CTEK representative using an original part supplied
by CTEK. A detachable cable can be replaced by the user using an original part supplied by
CTEK.
• Never extend the charger cable to a total length of more than 3.0 m. Use only original parts
supplied by CTEK.
• Extension of output cable may cause electromagnetic interference.
• Connection to the mains supply must be in accordance with the national regulations for
electrical installations.
• Chargers with grounded mains plug must only be connected to a grounded socket outlet.
• During charging, lead-acid batteries can emit explosive gases. Prevent sparks close to the
battery. Provide for good ventilation.
• Chargers with IP-class lower than IPX4 are designed for indoor use. See technical
specification. Do not expose to rain or snow.
• Connect the charger to the battery’s positive pole and then to the negative pole. Then
connect the charger to mains supply.
• For batteries mounted inside a vehicle, connect the charger to the battery’s positive pole and
then to the vehicle chassis remote from the fuel pipe. Then connect the charger to mains
supply.
• Disconnect the charger from the mains supply. Next remove the negative connection (vehicle
chassis) and then the positive connection.
• Don’t leave any battery unattended for a longer period of time during charging. If any error
occurs disconnect the charger manually.
• (IEC 7.12 ed.5) This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety. Children should be supervised to ensure that they do not play
with the appliance.
(EN 7.12) This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities, or lack of experience and knowledge if
they have been given supervision or instruction concerning use of the appliance in a safe way
and understand the hazards involved. Children must not play with the appliance. Cleaning and
user maintenance must not be made by children without supervision.