4
Aerial work platform
B-LIFT 18 HV
COD. UM0287_GB | REV. 0.0 | ED: 09/18
GB
Chapter 6
PROCEDURES FOR USE
•
Start the engine following as indicated in the vehicle’s instruction manual.
•
If the vehicle is equipped with an engine speed regulation device, slightly increase the speed
of the engine.
CAUTION
Never exceed 1000 RPM.
The engine could overheat or the pump could break.
6.3.3
Engaging the power take-off:
Procedure (Fig. 6.1):
•
Fully depress the clutch;
•
if engaged mechanically, move the control lever (1), located between the seats, into the
“ENGAGE” position; If it is engaged electronically: press the button (2) on the control panel
that activates the PTO;
•
the PTO indicator (5) will come on, an acoustic warning signal will sound and the hour counter
will start;
•
if the vehicle has an electromagnetic clutch with switch (refer to the vehicle’s instruction manual),
a visual and a sound signal is activated when the power take-off is engaged;
•
raise the clutch pedal slowly;
•
place the magnetic beacon light (3) on the roof of the machine and turn it on by inserting the
plug in the cigar lighter socket.
7
6
3
5
2
1
Fig.
6.1
CAUTION
Before starting any manoeuvre (in cold weather), it is advisable to run the
hydraulic system pump at idle speed for a few minutes so that the oil reaches
the minimum working temperature (about 40°) to allow it to low correctly.
6.3.4
Stabilising the elevating work platform (MEWP)
