CTC Union SHDTU03b, Руководство пользователя

Страница: 84 / 96

84
tagged members. Use PVID command to change the member port to untagged members
To assign PVID (Port VID), move the cursor “>>” to PVID and press enter. The port index 1 to 4
represents LAN1 to LAN4 respectively and port index 5 to 12 represents WAN1 to WAN8. VID value is
the group at which you want to assign the PVID of the port. PVID is
----------------------------------------------------------------------
Command: setup vlan pvid <1~12> <1~4094>
Message: Please input the following information.
Port index <1~12>:
1
VID Value (Enter for default) <10>: 10
----------------------------------------------------------------------
To modify the link type of the port, move the cursor to link mode and press enter. There are two types of
link: access and trunk. Trunk link will send the tagged packet form the port and access link will send
un-tagged packet form the port. Port index 1 to 4 represents LAN1 to LAN4 respectively. According to
the operation mode of the device, link type of WAN port is automatically configured. If the product
operates in bridge mode, the WAN link type will be trunk, and in routing mode, access.
----------------------------------------------------------------------
Command: setup vlan link_mode <1~12> <Access|Trunk>
Message: Please input the following information.
Port index <1~12>:
1
Port link type (Tab select) <Trunk>: Access
----------------------------------------------------------------------
To view the VLAN table, move the cursor to list and press enter.
14.16.7 Route
You can setup the routing parameters in route command. If the product is configured as a bridge, you
do not want to setup the route parameters. Move the cursor “
>> “ to route and press enter.
>> static Configure static routing table
rip Configure RIP tool
If the Router is connected to more than one network, it may be necessary to set up a static route
between them. A static route is a pre-determined pathway that network information must travel to reach
a specific host or network.
With Dynamic Routing, you can enable the Router to automatically adjust to physical changes in the
network’s layout. The Cable/DSL Firewall Router, using the RIP protocol, determines the network
packets’ route based on the fewest number of hops between the source and the destination. The RIP
protocol regularly broadcasts routing information to other routers on the network.
You can setup 20 sets of static route in static command. After entering
static menu, the screen will
show as follow:
>> add Add static route entry
delete Delete static route entry
list Show static routing table