M12 Cable Connector Installation
Before assembling M12 cable, make sure you have the
following M12 cable connector components and cable at hand.
Assembly Steps:
Step 1.
Thread the screw nut, O-ring, and housing over the cable
in the order shown below and keep them loose in this step.
Step 2.
Strip the cable and the individual cores to fit the
connector. Insert the stripped wires into the opened
contact clamps.
Step 3.
Tighten the connector by turning clockwise, making sure
that the wires inside the connector are not twisted as the
screwed housing is assembled.
Use a flat-head screwdriver to unlock and remove the device from the
din rail when un-mounting.
Insert the flat-head screwdriver into the indicated din rail snap level
hole.
Push up the flat-head screwdriver to pull the din rail snap level open.
Figure 21: Un-mounting
Application
Wall-Mounting and DIN Rail
The ITP-G800M/G802SM-8PH(E)24 Series come with both wall
mount (standard accessory) and DIN rail hardware brackets
(optional accessory). The wall mount bracket has been attached
to the device. Therefore, there is no need to install wall mount
bracket.
Figure 18: Wall mounting
When installing the DIN rail bracket, be sure to correctly align
the orientation pin (Figure 19). The DIN Rail bracket has a steel
spring in the upper rail of the bracket. This spring is compressed
for mounting and un-mounting by applying downward force.
Figure 19: Din rail installation
Figure 20: Mounting
- 11 -
Figure 15: Thread components over the cable
Figure 16: Insert the stripped wires to contact clamps
Screw Nut
Housing
Male Contact
Connector
O-Ring
Figure 17: Tighten the connector
- 12 -
www.ctcu.com
- 13 -
- 14 -
Figure 22: Onboard train application for ITP Series
NOTES:
Wall mounting
holes
Wall mounting
holes
