Chapter 3: Installing the PA PowerStation
Installing the PA PowerStation
PA PowerStation User Guide
33
Installing the PA
PowerStation
Once you prepared the location for the PA PowerStation, you can
install the unit. Installation will involve mounting the PowerStation
and if you are using CTC’s optional AC Power Supply, mounting the
power supply. Both procedures are described below.
Mounting the PA
PowerStation
The PA PowerStation is designed to be mounted using 4 - 6 screws.
These screws are secured to the unit with metal clips. For your
convenience, CTC includes all necessary mounting hardware with the
unit.
Mount the PowerStation
Note
Necessary mounting clamps and screws are shipped with your
system.
To mount the unit, complete the following steps:
1.
Prepare the power source for the unit by sliding the positive and
negative wires into the appropriate slots on the power connector.
See Figure 3-6.
Figure 3-6 Power Connector and Positive/Negative wires
2.
Connect the ground cable from the power connector to an earth
ground.
3.
Gently insert the PA PowerStation into the cutout from the front.
4.
Attach the 4-6 mounting clamps, with their screws, to the back of
the unit in the spaces provided.
Note
The number of clamps depends on the model. The shape of the
prongs at the bottom of each clamp also depends on the model.
The 5", 6", and 8" models use a T-shape clamp, and the 10"
models use an L-shape clamp.
Ground wire
Negative wire
Positive wire
Power
connector
StockCheck.com