PC9/P9 CD-ROM Replacement
4
CTC Parker Automation
2. Disconnect the power and data (ribbon) cables attached to the CD-
ROM drive.
Note
Note where these cables are attached to the CD-ROM drive so
that you can re-attach them to the new drive later.
3. Remove the four retaining screws holding the CD-ROM drive in
place.
4. Slide the CD-ROM drive out of the unit to the left.
Installing a CD-ROM Drive
To install a new CD-ROM drive, follow these steps:
1. Slide the new CD-ROM drive into the unit from the outside (left
to right).
2. Fasten the drive in place by replacing the four retaining screws
that you removed in step 3 above.
3. Re-attach to the CD-ROM drive the power and data cables that
you disconnected in step 2 on page 4, when you removed the old
drive.
Slide CD-ROM drive out of the unit to the left
CD-ROM drive
Disconnect
Remove these screws
Remove these screws
cables here