3. SETTING UP CABLE ROUTING
WITH ONLY (1) PANEL BACK IN, SLIDE IN THE POWER CORDS AND ANY OTHER CORDS THAT WOULD NEED TO BE CONNECTED TO THE TABLET THROUGH
THE BODY AS SHOWN. THERE WILL BE GAPS AT THE TOP AND BOTTOM FOR THEM TO ROUTE OUT TO THE POWER SOURCE AND TO THE DEVICE. SLIDE IN
SECOND PANEL WHEN ROUTING IS FINISHED.
888-733-4448
4. INSTALLING THE TRAY, GOOSENECK & VESA
1. USING THE SMALL FLAT
HEAD SCREWS, SCREW
IN THE VESA TO THE
GOOSENECK WITH THE
PROVIDED TOOL
2. SCREW IN THE
GOOSENECK BODY TO
THE TRAY TABLE AS
SHOWN WITH THE
SMALLER FLATHEAD
SCREWS
3.CABLE ROUTE THE WIRE
FROM THE STAND THROUGH
THE GOOSENECK AND OUT
THE VESA. THEN SCREW IN
THE TRAY TO THE STAND
WITH THE REMAINING
LARGER FLATHEAD SCREWS.
5. INSTALLING THE ENCLOSURE
WHILE HOLDING THE HEX NUT FROM BEHIND THE X-VESA PLATE,
SCREW IN THE SCREWS FROM THE FRONT OF THE ENCLOSURE
ETHROUGH THE ENCLOSURE AND VESA INTO THE HEX NUT WITH
THE PROVIDED TOOL UNTIL SECURELY TIGHTENED.
