CSZ Norm-O-Temp 111W, Руководство по эксплуатации и техническому обслуживанию

Страница: 50 / 82

Operation / Technical Manual NORM-O-TEMP
®
, Model 111W
Page 50 of 82
6-1.2. Replace / Reinstall the Top of the Unit
Re-Install top as it was removed in Section 6-1.1.
NOTE: When securing the top, be sure the fill spout gasket inner lip on the
aluminum cover top is in the up position and the fill spout goes directly
into it.
6-1.3. Removing the Three-Sided Enclosure Panel
A. Loosen the top of the unit as described in Section 6-1.1.
B.
If an I.V. pole is attached to the stand, remove the two phillips screws from
the U-shaped bracket that secures the I.V. pole to the unit. Put the bracket
and screws aside.
C. Remove the six remaining phillips head screws that secure the three-sided
panel to the unit.
D.
Remove the enclosure panel and put aside or discard if it is being replaced.
6-1.4. Replace / Reinstall the Three-Sided Enclosure Panel
Re-Install enclosure as it was removed in Section 6-1.3.
6-2. Replacement of the Heater
A. Collect the following required items:
1. 7/8 inch wrench
2. Teflon tape
3. Replacement heater
4. 6-32 Kep Nut
5. 5/16 inch Nut Driver
B. Drain the reservoir as described in Section 5-1.4.
C.
Remove the three-sided enclosure panel as described in Section 6-1.3.
D. Locate the heater inserted in the lower front part of the reservoir.
E. Disconnect the two heater wires attached to the power supply board.
F. Using a 5/16 inch nut driver unscrew the 6-32 kep nut to disconnect the ground
wire.
G. Using a 7/8 inch wrench, unscrew the heater and pull it from the reservoir.