11
The contents of this install guide are copyright protected and may not be reproduced in any form without prior written consent of CSR. Recommendations and
advice regarding the use of the products described in this guide are to be taken as a guide only, and are given without liability on the part of the company or
its employees. We reserve the right to change product specifications without prior notification, please refer to the CSR website for the latest version of this
document. The purchaser should independently determine the suitability of the product for the intended use and application.
g.
Secure Varipitch to Flashing:
Reposition the Varipitch on the Flashing and check it is
horizontal - secure the Varipitch to the flashing using the recommended number of screws
shown in the table below –
DO NOT SEAL
this connection.
h.
Assemble Turbine:
Assemble the turbine head to the Varipitch. Re-check if the assembly is
level (horizontal) and adjust the turbine by tilting the throat slightly if required. Ensure the
knurling (the tapered section of the Varipitch) is fully inside the ventilator throat and secure the
ventilator throat by fastening it to the top of the Varipitch with the number of fasteners shown in
the table below.
NOTE
:
DO NOT
apply sealant to the joint between the turbine and Varipitch. This is a natural
gutter to release any trapped condensation. See details in section (i) below.
Model
Fasteners to
secure
varipitch to
flashing
EcoPower 400
Hurricane 100 - 400
6
EcoPower 600
Hurricane 450 - 600
9
EcoPower 900
Hurricane 700 - 900
12
Use 10G X 16MM Galvanised Self Drilling TEK
Screws with Neoprene Washer or 5/32" (4.0mm)
Rivets Aluminium/Steel Sealed
Model
Fasteners to
secure turbine
to varipitch
EcoPower 400
Hurricane 100 - 400
6
EcoPower 600
Hurricane 450 - 600
9
EcoPower 900
Hurricane 700 - 900
12
Use 10G X 16MM Galvanised Self Drilling TEK
Screws with Neoprene Washer or 5/32" (4.0mm)
Rivets Aluminium/Steel Sealed
