CSI 7798 I/SITE LAN, Руководство по установке

Страница: 39 / 56

Installation Guide Setup and Operation
7798 I/SITE LAN 33
Test mode
To edit the test mode, press
>
to toggle between Test and Normal.
Manual Mode
To edit the manual mode, press
>
to toggle between Manual and Normal.
Unacknowledged
Pressing
>
sends an alarm acknowledgment signal to the point no matter what the
current unacknowledged state is.
After you have completed all desired changes, press
ESC
to exit the Point Control screen
and save all changes made.
ATS Override
Selecting one of the points from the ATS override point summary, displays the override
edit menu (see
Figure 27 ).
The override edit screen displays Point name, Start time, and Stop time parameters. The
Start time and Stop time parameters consist of two separate fields displayed in a 24-hour
clock format (HH hours and MM minutes). The standard editing screen displays as a
part of the override edit screen. The time can be changed by the following steps:
1. Select
Start time
or
Stop time
.
Note: The Stop time is the time the override releases, and the current schedule is resumed.
2. Select either hours (HH) or minutes (MM) using the left or right arrow keys.
3. Press the
+
/
–
keys to select the time desired, up to 23:59, then press
Done
to store
the entry.
4. Repeat steps 2 and 3 as necessary.
5. Press
Done
to save the override time interval and exit, or press
ESC
to exit without
saving.
Note: If a start time is not specified, the override begins when you exit the ATS override screen by
pressing “Done”.
Figure 27. Override Edit Screen
F4
F2
F3
F1
F8
F6
F7
F5
Point name
→
←
Start time
Stop time
Fan
00:00
00:00
Done
ESC
+
—