10
Diagnostic
Display/failure
Reason
Correction
Interference
Power of the transmit
-
ter too low
Check batteries and an
-
tenna of the transmit
-
ter. Antenna must be
fully extended!
Antenna in the car is
rolled up
Refer to installation
Antenna is near the
speed controller and/or
the battery cables
Refer to installation
Receiver defect
Exchange receiver
Crystal defect
Exchange crystals
Car does not stop
Set the trim triggers at
the transmitter.
Water or humidity
damage, send in for
repair!
9. Safety precautions
- Not for children below 14 years. No toy!
- The CE-certificate of this speed controllers does not exempt from the
obligation to handle this product with care.
- Use only motors from CS-ELECTRONIC which are intended for the used
voltage range!
- Use only high performance batteries from CS-ELECTRONIC.
- Do not leave you RC-model unsupervised as far as a battery is connected.
In case of a failure this can be cause fire.
- The speed controller and other electronic components should never get
in touch with water. The speed controller must be protected against dust,
dirt, humidity and vibration.
- If the motor is connected to the speed controller, the motor may never
be run with an external battery. This destroys the speed controller and
the guarantee is lost.
- Never reverse connect the polarity of the speed controller. Use a reverse
connected protection plug systems. Avoid short circuits and blocked mo
-
tors.
- All cables and connections must be isolated properly. Short circuits can
destroy the speed controller.
- The speed controller may be only used in battery driven, radio controlled
models. Another use of the speed controller is not permitted. The use in
a model for carrying of passengers is forbidden!
- First check the holdup of your radio control (hold you model tight) before
using you model.
- It is not allowed to modify the speed controller in another way as de
-
scribed in this manual.
- Exclusion of liability: The retention of the assembly and the users-instruc
-
tion as well as the conditions and methods of installation, operating, use
and maintenance can not be supervised by CS-ELECTRONIC. Therefore
CS-ELECTRONIC does not take over any liability for losses, damages or
costs, which result from a faulty use or operating or are connected in any
kind to such conditions.
- Only components and spare parts recommended by CS-ELECTRONIC may
be used. Use only suitable plugs original from CS-ELECTRONIC.
- Please be sure, that your transmitter is working on a free frequency, is
switched on and the throttle trigger is in neutral position before connect
-
ing the speed controller and using the model.