Crystal Vision
Appendix 2
Note:
Once the IP address has been changed the status page will be accessible via this new
address.
Note:
It is possible to verify that the correct frame is being viewed by first recording the Hex switch
setting (second line in status list) – this is the setting of the frame address switch. Rotate this
switch to something other than the number displayed. Refreshing the browser will then reflect
this change and verify that the correct frame is being communicated with.
Status
The status page gives an overview of the frame and its power supplies. The information that
can be found here includes general information about the network attributes, frame name and
serial number etc plus more frame specific information like internal temperature, fan status
and PSU type. Further information is also given about the individual power supplies.
Changing the IP Address
An Ethernet-enabled frame will need to have its IP address set upon installation. This is made
possible by setting the frame to act as a web server and then accessing an internal web page.
Any software upgrades can also be downloaded to the frame via this web page.
From this web page you are able then to change the IP address manually or automatically if
DHCP is available. A frame serial number may also be entered.
To reset the IP address, from the status page select the Network link. A new page will open
allowing entry of the required IP address and Netmask. Enter the new IP address and Netmask
information and select ‘Store’. Should the frame be connected to a DHCP running network and
a fixed IP address is not required, leave all the information blank and tick the DHCP box before
selecting ‘Store’.
Network Window
Once ‘Store’ has been selected the Network screen will be replaced by a confirmation screen.
As instructed lever four must be returned to the up position and the front panel power cycled.
This can be achieved by either briefly interrupting the power to the frame or, if this is not
convenient, removing the ribbon-cable connection to the front panel. Care must be taken not to
bend any pins in the cable connect as attempting to re-straighten any bent pins is likely to result
in their fracture.
Indigo 2AE and 2SE User Manual R1.17
68
27 February 2020
