5- 15
. Hot Tank Heater Replacement Procedure
1. Remove Refrigeration System (Refer to RRS Removal Procedure).
2. Stand RRS system on bench or table for easier access to components
(fig.2-1).
3. Unplug wire connector from heater band that goes to the manual reset, which is mounted
along with the auto cutout, in the bracket directly above the heater tightening screw
(fig.3-1).
4. Unplug wire connector from heater band that goes down to the compressor
(fig.4-1).
5. Loosen and remove tightening screw that secures heater band to the hot tank
(fig.5-1) and
slide heater down
(fig.5-2) and over support bracket and drain tube.** Save the heater band film
that is between the heater and tank and re-use with the new heater.
6. Install new heater in the reverse order
Note: Push the manual reset button in before re-assembling unit.
figure 2-1
figure 3-1
figure 4-1
figure 5-1 figure 5-2