INTERFACING SOLUTIONS
WVIGM-04M
Wi-Fi AUDIO/ VIDEO INTERFACE
FOR SELECT CHEVROLET, CADILLAC
& GMC VEHICLES 2013-UP
www.cruxinterfacing.com
Rev. 091714
6
CONNECTING THE INTERFACE
Follow these steps to properly install the interface module.
Step 5
- After connecting the module, set the proper dip switches to the “ON” position.
The interface requires DIP Switch 1 to be “ON”. Unless you are using the toggle switch option.
DIP SWITCH DESCRIPTION
Up = ON, Down = OFF
DIP 1 = Video In-Motion (Always On)
DIP 2 = Factory Rear-View Camera
DIP 3 = Not Used
DIP 4 = Not Used
DIP 5 = May Vary
DIP 6 = May Vary
After each change of the DIP switch settings,
we recommend powering down the module,
then restarting the module.
LED INDICATORS
BLUE LED:
Blinking = No BUS Detected.
Solid = BUS Recognized.
OFF = Power Down/ Sleep mode.
RED LED:
ON = Power On
OFF = Power OFF
TO FACTORY
HARNESS
GREEN/ VDO UNLOCK
WHITE/ 12V OUTPUT
TAP HERE/ BLACK WIRE
10-PIN
(male plug)
Wi-Fi
INTERFACE
BLACK/
GROUND
FACTORY
A/V INPUT
TO FACTORY
A/V INPUT
8-PIN
(male plug)
RED/
12V POWER
4 5 6
ON
1 2 3
STATUS LED’S
16-PIN
(male plug)
16-PIN
(female plug)
4 5 6
ON
1 2 3
DIP 1 = ON
2
3
4
5 = MAY VARY
DIP 6 = MAY VARY
OFF
ACTIVATE
VIDEO
IN-MOTION
OPTIONAL/
TOGGLE SWITCH
ENABLE
DISABLE
DIP 2: If the vehicle is equipped with
factory rear-view camera, place to ON.
DIPS 5 & 6:
These two dip switches control the
CAN-Bus configuration.
Switches “5” and “6” are defaulted to
“OFF”, test the video in-motion, If there is
no display on the screen while the vehicle
is in motion, please place switches “5” and
“6” to “ON”.