Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.061319
4 of 5
RADIO REPLACEMENT
SWC RETENTION
+
R
INTERFACING SOLUTIONS
VIMMB-85S
Video In Motion Activation for
select Mercedes Benz Vehicles with NTG3, 3.5 & 5 Systems
For COMAND NTG5 Systems (W222 / C2
17)
Tap the power and ground wires of the VIMMB-85S harness
following the diagram on page 1. The CAN wires are connected
at the CAN distribution block located at the driver side foot
well area (close to the OBD connector). It is usually covered
with a plastic flap.
Unplug the 3 pin connector (with brown
wire) on the CAN distribution block. Use a
pick tool and press down the terminal lock
on the PIN 2 Yellow/White (or Pink/White)
wire (CAN HIGH) and PIN 3 Yellow (or Pink)
wire (CAN LOW). Unplug the terminal wires
and insert them to the 3 pin socket included
in the kit following the diagram below.
CAN Low (Yellow or Pink) PIN 1
CAN High (Yellow/White or Pink/White) PIN 3
Connect the 3 pin socket to the corresponding 3 pin plug found on the VIMMB-78S harness.
Insert the Yellow/Black wire from the
VIMMB-78S harness into PIN 2 and the Blue/
Black wire to PIN 3 of the 3 pin connector on
the Comand distribution block.
