Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.031220
TDR-RVM32
Rear-View Mirror with Front and Rear Camera,
DVR and GPS Functions
2 of 4
R
INTERFACING SOLUTIONS
INSTALLATION INSTRUCTIONS:
BACKUP CAMERA
1. Run the backup camera extension cable from the rear view mirror location along the headliner and
towards the trunk of the vehicle. Look for a suitable location for the backup camera and install using the
bracket. Tap the Red camera power wire to +12V backup light and the black wire to ground. Plug in the
camera cable to the extension cable connector.
GPS ANTENNA
2. Run the GPS antenna cable from the rear view mirror location towards the A pillar. Attach the GPS
antenna on the dashboard using double sided tape.
POWER CONNECTION
3. Starting from the rear view mirror location, run the power harness towards the fuseblock. The
fuseblock can be located either on the driver or passenger side wall. Look for a fuse that has constant
power (Battery) with 10 Amp capacity. Remove the fuse and insert the Yellow fused wire of the power
harness. Look for a fuse that is switched power (ACC) with 10 Amp capacity. Remove the fuse and insert
the RED fused wire of the power harness. Tap the ground terminal to a solid ground point such as a
screw or bolt.
MIRROR/DVR INSTALLATION
4. Plug in the GPS antenna, backup camera and mini USB power connectors to the mirror/DVR. Use the
rubber straps provided to secure the mirror in front of the original rear view mirror. Slide out the front
camera assembly to clear the rear view mirror.
TESTING THE MIRROR/DVR
Turn ignition on and test the front camera for functionality. Put the gear in reverse and check for the
backup camera image.
NOTE:
Do not remove the TF card while the mirror/DVR is powered on to avoid damaging the TF card.
It is recommended that the installer test the mirror/DVR and backup camera for functionality before
doing a permanent install. Power the mirror/DVR using the provided 5V power supply harness. Plug in
the backup camera and GPS antenna. Insert the TF card provided. Turn on the mirror/DVR power button.
Check if front camera and backup camera image can be seen. Touch the mirror to change options. The
DVR should be recording as soon as power is applied to the mirror.
