SETTING THE AFTERMARKET RADIO
BRAND
This step is only necessary if the vehicle has steering wheel controls and you are installing one of the radios listed. With
the key in the off position, set the DIP switches to the corresponding radio listed below
.
3.5MM SWC CABLE
The SWRVL-54 Module allows for both types of connections:
OPTION A
is used for ALPINE, CLARION, JVC, and KENWOOD units (Blue/Yellow wire is attached)
OPTION B
is used for BOSS, DUAL, FAHRENHEIT, JENSEN, POWER ACOUSTIK, PIONEER, SONY and
SOUND STREAM units.
NOTE:
Cap or insulate the 3.5mm plug or Blue/Yellow wire if not being used.
BOSS Radio SWC Programming
SWC Radio Wiring connection
SWC Key1 (Brown-wire) connect to Female 3.5 mm Jack - Brown wire
SWC Key2 (White-wire) connect to Female 3.5 mm Jack - Brown/White wire
SWC GND (Black-Wire) connect to Radio Negative wire (Black)
Programming the Radio
Press: [SETTING] > [STEER] > [RESET] > [High Z]
Press the Steering Wheel Control (SWC) buttons set the values as listed below:
Vol
–
[ 4.07]
Vol + [ 3.66]
Seek
–
[ 3.37]
Seek + [ 2.98]
Mode [1.39]
OFF Hook [ 0.00]
The Value in the bracket [X.XX] will vary and will be used as parameter for each assigned function.
Press: [Assign] > [4.07] > [Vol-], then the [4.07] will be replaced with [ Vol-]
With [Assign] highlighted:
Press: [3.66] > [Vol+], then the [3.66] will be replaced with [Vol+]
Press: [3.37] > [Seek-], then the [3.37] will be replaced with [Seek-]
Press: [2.98] > [Seek+], then the [2.98] will be replaced with [Seek+]
Press: [1.39] > [Mode], then the [1.39] will be replaced with [Mode]
Press: [0.00] > [Call], then the [0.00] will be replaced with [Call]
Press: [Enter] for Save the setting and Exit
USING A RELAY
The module is rated at up to
2A
max power output. For
applications demanding a continuous output of 3A or more,
we recommend using a standard Bosch (SPDT) relay.
rev.041917
2/2
