Note
: DIP switch functions of the VIMPR-90P
Dip 1
–
Activate Video In Motion
Dip 2
–
no function
Dip 3
–
no function
Dip 4
–
no function
Dip 5
–
CAN-bus termination resistor on the vehicle side
Dip 6
–
CAN-bus termination resistor on the head-unit side
NOTE: Vehicles with affected navigation performance
On some vehicles, the navigation performance is affected as long as the video-in-motion function is
activated. This can only be detected by a test drive and with DIP# 1 set to ON.
If the navigation performance is affected you have to set DIP#1 to OFF. As long as the video-in-motion
function is activated, the navigation will NOT work. The green wire on the T-harness can be used to
activate the video-in-motion function (Video-in-motion selective) by connecting a switch (not included)
between the GREEN wire and +12V ACC.
Cable colour
Assignment
●
Red
+12V Constant Pin 18
●
Brown
Ground Pin 17
●
●
Orange/Violet
CAN HIGH Pin 6
●
●
Orange/Brown
CAN LOW Pin 12
ACTIVATING AND DEACTIVATING THE VIM FEATURE
The video-in-motion can be activated and deactivated either by setting DIP# 1 to ON (permanent VIM)
or by the connecting a switch (not included) between the GREEN wire and +12V (selective VIM).
Video-in-motion permanent
With DIP#1 set to ON, the video-in-motion function is activated permanently without disturbing the
navigation performance.
Video-in-motion selective
With DIP#1 set to OFF, the GREEN wire is used to activate the video-in-motion function.
Connect a switch between the GREEN wire and +12V ACC.
●
+12V = VIM is activated
●
0V = VIM is deactivated
3 / 3
rev.121818
