Crux Interfacing Solutions • 6860 Canby Ave., Suite 116, Reseda, CA 91335
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.052318
CFD-03E
FORD Emblem Camera
for Select Ford Trucks
R
INTERFACING SOLUTIONS
Sightline
CAMERAS
INSTALLATION PROCEDURE:
1. Remove the Ford Emblem.
2. The OEM holes behind the emblem
will look like this. If your tailgate does
not have these holes, you need to cut
a hole using a drill and the hole saw.
Use a le to smooth out the edges.
3. Some trucks have a hole on the bed
behind the tailgate like on the picture
above. If your truck does not have this
hole, use the hole saw to drill one. Use
a file to smooth the edges.
4. Route the wiring through the tailgate
hole down the opening at the base of
the tailgate.
5. Press in the emblem to cover the
base.
6. Route the harness through the hole
on the truck bed and run it towards the
front of the truck.
Camera Specications:
Resolution: 420 TV Lines
Pixels: 656 x 492
Viewing Angle: 170-degrees
Minimum Illumination: 0.2 Lux
Shutter Speed: 1/60s-20us
Voltage: 12V Negative Ground
7. Tap +12V from the reverse light wire
using the supplied 3 ft. power plug or
use the power extension wire built into
the video cable to tap to the reverse
signal wire from an aftermarket radio.
8. To integrate the CFD-03E back-up
camera with the MyFord Touch 8”
screen radio of select 2011-up Ford
vehicles, use part# RVCFD-79 Rear-View
Integration Kit (not included).
2 / 2
