CrustBuster Speed King Seed Tote 4 Box, Руководство оператора

Страница: 17 / 38

BELT TIGHTENING
INSTRUCTIONS
Belt should be tightened before you train
the belt. Tightening the belt is done on
the head roller by tightening the take up
bars evenly. Belt is tight when applying
25 lbs. of force, centered between the
return rollers, there is no more than 2
inches of deflection.
BELT ASSEMBLY INSTRUCTIONS
At the start point, see view of head and tail assembly. Drop belt
over the top of head roller and gravity feed belt down the tender
tube to the bottom. Guide the belt over the top of the tail roller.
Make sure rough side is UP and the smooth side is DOWN
against the inside of wall of the tube.
Route both ends around head and tail rollers and over all return
idlers mounted under the tube. Slide belt forward or back
through tube so the ends of the belt meet at a convenient
location between return idlers to facilitate joining.
Align and interlace belt and clipper lacings. Slip splice pin
(Plastic covered cable) through clipper lacings to secure.
Belt Assembly
FOR FERTILIZER USE ONLY
Apply rubber adhesive, from tube furnished, to both sides of clipper lacing. This is
not done at the factory before shipping. Smooth adhesive and allow to set in
accordance with package directions. This rubber adhesive secures splice pin in
place and seals, so fertilizer dust does not settle on back side of belt and cause
inside of tube to rust.
Tighten belt by turning adjustment bolts on head assembly in. Tighten evenly on
each side until belt is tight.
To train belt, see belt training instructions in this manual.
14