CrustBuster Seed Box Tote, Руководство пользователя

Страница: 55 / 59

Remote Control
To Program Remote:
Power up the unit. When you do so, the LED on the receiver unit will flash RED four times. This indicates that
the unit has received power. There is magnetically controlled switching circuitry embedded in the receiver unit.
Place a fairly powerful magnet over the receiver “learn” area (near R11) for a brief moment (3 seconds), and then
remove it. The LED will go to constant RED state. Now immediately press any button on the transmitter you are
attempting to learn in. The LED will go to a GREEN/YELLOW color. This confirms that the receiver has picked
up a signal from the transmitter, and subsequently learned that signal. Communication has been established, and
it is now ready to function properly.
Troubleshooting:
Should the above procedure not complete successfully, wait until the LED light goes out, and repeat the
procedure. If for any reason you experience a second failure of the learn procedure, do the following. Place the
magnet on the learn area and the LED will go to a constant RED state. Leave the magnet in place on the receiver
until the LED light goes out (approximately 10 seconds). This action completely clears the receiver’s memory.
It’s akin to reformatting, or freeing up all of the space on a computer hard drive. Once you have cleared the
memory, proceed with the standard learn procedure detailed above for each of the key fob transmitters you wish
to use with the device. If, after all of the procedures detailed above are completed, the unit is still not functioning,
check the battery in the transmitter once again. (Occasionally, even new batteries fail, or are defective from the
factory. If you have a voltage meter, confirm that battery voltage is at least 2.7 volts.) If that still does not solve
the problem, contact CrustBuster/Speed King, Inc. At (620) 227-7106.
Battery:
It is recommended that the battery be replaced every year.
53