Crusader CWS5-031, Руководство пользователя

Страница: 18 / 26

18 | P a g e
Crusader
5.0
& Crusader
6.0
Lamp Countdown Reset Sequence
After changing the lamp on the Crusader
5.0
& Crusader
.0
systems, the controller must be reset in
order for the system to begin its countdown function on the newly installed lamp. To perform this
reset, you must firmly depress the button on the front of the controller and then manually plug the
power cord back into the wall outlet initiating power to the unit. Keep holding down the button for
five seconds until you hear an audible chirp indicating the controller has reset the internal timer.
Release the switch and the lamp countdown feature has now been reset. The following two screens
will be displayed during this process.
Crusader
5.0
& Crusader
6.0
Failure Modes
The Crusader controller continuously monitors your UV system and if there is a problem with the
system the controller will provide both a visual and audible signal indicating the specific fault that
may be adversely affecting the operation of your system. The fault conditions are listed in a priority
sequence as follows:
LAMP FAILURE:
If at any time during the operation of the
system, the UV lamp fails to be illuminated, the controller will
return both an audible and visual signal indicating lamp failure. In
addition, a constant audible buzzer will sound during lamp failure.
UV SENSOR FAILURE:
Assuming the system has a UV Sensor
installed, if at any time during the operation of the system, a UV
sensor fails, the controller will return both an audible and visual
signal indicating sensor failure. For sensor failure, the controller
will cycle between “sensor failure” and “water may be unsafe for
consumption” screens as an added precaution. In addition, a
constant audible buzzer will sound during sensor failure.