WWW.CRUINC.COM • (800) 260-9800
WWW.CRUINC.COM • (800) 260-9800
Diagram 5
Diagram 6
Diagram 7
I
NSTALLING
THE
H
ARD
D
ISK
D
RIVE
(DP350)
1. Remove the four screws in the corners of the back of the
enclosure.
2. Slide the covers up and away from the back of the enclosure.
3. On the top is a metal cover. On the end there are two indents;
grip them with your fingers and pull the metal cover off towards
the rear of the enclosure (see Diagram 5).
4. Remove the front bezel by depressing the clips on the front of
the enclosure. Slide the front bezel off the front of the enclo-
sure.
5. Plug the data cable and the power cable into the hard disk
drive. Slide the drive into the enclosure. Guide the power
cables underneath the connectors on the power switch. Fasten
the drive to the bottom of the enclosure with the provided
screws (see Diagram 6).
6. When sliding the hard drive into the enclosure make sure the
cable is pulled upwards or push the cable down into the enclo-
sure. If the cable is pulled upward, fold the data cable over top
of the hard disk drive. Place cable so it will not interfere with
drive insertion.
7. Slide the covers back on and snap them into place. Re-install
the four screws in the back of the enclosure (see Diagram 7).
8. Connect the USB/FireWire cable from the computer’s
FireWire or USB port to the enclosure.
9. Plug the provided power cable into the back of the enclosure.
6
7
