2
WMA 076 R04
Before Installing
1.
Thoroughly clean the mounting surface to remove any dirt, residue or contaminates
that may reduce the adhesive performance.
2.
Ensure the mounting surface is thoroughly dry and free from loose, flaky material.
Assembly
1.
First assemble a wall bracket (G) over the foot pole section (C) so that the end of
the bracket points away from the plastic foot at the end of the pole. See Fig 1.
2.
Then place a wall bracket (G) over the top pole section (B) as shown so that the end
of the bracket points towards the plastic foot at the end of the pole. See Fig 2.
3.
Slide a large rubber o-ring (F) over the foot pole section (C) followed by a small
rubber o-ring (E). Next slide the tapered section of a basket (D) over the pole
and fully locate onto the two o-rings to retain the basket. Fig 3.
Note. It is important that the o-rings are assembled correctly on the pole in the
order shown or the basket will not fully locate securely onto them.
4.
Then, slide a large rubber o-ring (F) onto the middle pole section (A) followed by a
small rubber o-ring (E) making sure that the tapered end of the pole points
towards the ceiling. Then slide a basket (D) onto the pole in the orientation shown
locating the tapered section of the basket onto the o-rings. See Fig 4.
Note. It is important that the o-rings are assembled correctly on the pole in the
order shown or the basket will not fully locate securely onto them.
5.
Take the top pole section (B) and slide a basket (D) onto the pole in the orientation
shown in Fig 5. Then slide on a small rubber o-ring (E ) followed by a large rubber
o-ring (F) and slide the tapered section of the basket (D) down the pole and locate
fully onto the o-rings. See Fig 5.
Note. It is important that the o-rings are assembled correctly on the pole in the
order shown or the basket will not fully locate securely onto them.
6.
Connect each of the three pole sub-assemblies together, ensuring to fit the two
remaining wall brackets on the pole either side of the middle basket in the
orientation shown in Fig 6.
(All wall brackets should point upwards as shown)
Fitting guide
1.
Plan where the assembled product will be located before removing the protective
backing
from
the
adhesive
pads.
Important Note - The adhesive pads can only be used once and cannot
be re-applied.
2.
Place the assembled product into its desired location ensuring that all poles are
vertically aligned and that the adhesive pads on the metal wall brackets are all
touching the same wall. Working one at a time from the top bracket down, rotate the
wall bracket around to gain access to the adhesive pad and peel the protective
backing off. Carefully rotate the bracket back around without allowing it to touch the
wall and position the bracket at the desired height on the pole. Firmly press the
bracket against the wall to stick in place. Repeat for the remaining brackets.
Important note - The adhesive pads must be left to cure for 24 hours before
weight is placed on the baskets and the product is used.
3.
To adjust the height of each basket whilst the unit is assembled to the wall, support
the pole with one hand and with the other carefully slide the basket upwards, off the
o-rings. Re-position the rubber o-rings at the desired height and relocate the basket
fully back onto the o-rings to secure in place.
Important note - Ensure each basket is fully located over the o-rings to
prevent the basket from working loose and sliding down the pole.
Assembly and Fitting guide
