Crown XTi 1002A, Руководство по эксплуатации

Страница: 6 / 24

XTi 2 . 5 Series Power Amplifier XTi 2 . 5
系列功率放大器
6
Operation Manual
操作手册
2.3 Ensure Proper Cooling
When using an equipment rack, mount units directly on top of each other. Close any open spaces in rack with blank panels.
DO NOT block front or rear air vents. The side walls of the rack should be a minimum of two inches ( 5 . 1 cm) away from the
amplifier sides, and the back of the rack should be open.
CAUTION: Before you begin installing your amplifier, make sure it is disconnected from
the power source, with the power switch in the “off” position and all level controls turned
completely down (counterclock wise).
2 . 2
安装功放
注意：开始安装前，确保您已断开功放与电源的连接，将功放电源开关设置到关闭位置，
并将所有音量调节到最低（逆时针旋转）。
使用一个标准的 19 寸（ 48 . 3 厘米）设备机架。具体功放尺寸请参见上图。您还可以直接将功放安放
到平台上，而不用将功放安装到机柜。
注：确保机架前后能稳固支撑功放。当将功放安装于机架上时，功放下面需有固定于机架
上的平板或导轨进行支撑。
2.2 Installing the amplifier
NOTE: Before you begin, make sure your amplifier is disconnected from the power source,
with the power switch in the “off” position and all level controls turned completely down
(counterclockwise).
Use a standard 19 -inch ( 48 . 3 cm) equipment rack. See above diagram for amplifier dimensions. You may also stack
amplifiers without using a cabinet.
NOTE: Amplifiers should be supported at both the front and rear of the rack. When stack the
amplifier with rack, flat plate or rails must be placed under amplifier to provide stable support.
3.5 In.
89 mm
19 In.
482 mm
12.25 In.
311 mm
16.2 In.
411 mm
XTi1002A
XTi2002A
XTi4002A
XTi6002A
2 .
安装
（接上一页）
2. Setup
(continued)
2 . 3
保证正常散热
在使用设备支架时，直接将设备安装在支架上。使用空面板将所有开放的空间封闭。不要阻挡前面
和后面的通风口。机架两侧与功放之间的间隙至少保持
2
英寸（
5 . 1 cm
），后面应该保持开放。
警告：安装功放前，确保功放已从电源上完全断开连接，且电源开关处于“关闭”状态，
所有的音量调到最低（逆时针最低点）。