Power-Tech .1 Series
Power Amplifiers
page 14
Operation Manual
Again, this should be possible only when oper-
ating outside rated conditions, as when the
amplifier is used to drive a 1-ohm load, or
when driving a severely clipped signal.
A Power-Tech .1 Series amplifier will not blow
its fuse or trip its breaker unless something is
wrong. In the rare event that an internal fuse
blows, please refer the unit to a qualified tech-
nician. If a breaker trips, try to identify and cor-
rect the problem before resetting the breaker.
The breaker for the Power-Tech 1.1 and 2.1 can
be reset using the front panel power switch. The
circuit breaker for a Power-Tech 3.1 can be
reset using the back panel reset switch. If the
problem persists, refer the unit to an authorized
Crown Service Center.
5.2 Option
5.2.1 MT-BB
The MT-BB is an accessory panel that provides
barrier strip input connectors. An MT-BB
accessory might be desirable in applications
requiring bare wire or spade lug connections.
Like other unused input connectors on your
Power-Tech .1 Series amplifier, these barrier
strip connectors can be used to daisy chain an
input signal from one amplifier to another.
Fig. 5.1 MT-BB
Important: The MT-BB must be installed
at a Crown Factory Service Center or the
Crown factory.
MT-BB
–
+
–
+
C H - 2 I N P U T
C H - 1 I N P U T
5 Advanced Features
and Options
