Crown PIP-CLP, Справочное руководство

Страница: 5 / 12

P.I.P.-CLP
Page 5
Reference Manual
Remember: Crown is not liable for
any damage resulting from over-
driving other components in your
sound system.
Fig. 2.3 Installation into a
PIP2 Amplifi er
Next, insert the edge con-
nector of the P.I.P.–CLP into
the PIP2 input adapter (see
Figure 2.3) and insert the as-
sembly into the PIP opening in
the back of the amplifi er.
4. Tighten the two PIP mounting
thumbscrews.
5. Reconnect input wiring.
6. Plug in the amplifi er and turn
it on. Adjust its level controls
to a desired setting.
Do not tamper with the circuitry.
Circuit changes made by unau-
thorized personnel, or unauthor-
ized circuit modifi cations, are not
allowed.
CAUTION: If your amplifier is
equipped with 1 /
4
-inch phone jacks
on the back panel, do not connect
input signals to them while the
P.I.P.-CLP is installed. Input sig-
nals connected to the phone jacks
will be altered by the output cir-
cuitry of the P.I.P.-CLP and result
in a distorted signal.
Crown Audio
Technical Support / Factory Service
1718 W. Mishawaka Rd., Elkhart,
Indiana 46517 U.S.A.
Telephone: 574-294-8200
800-342-6939
(North
America,
Puerto Rico, and
Virgin Islands only)
Facsimile: 574-294-8301
(Technical Support)
574-294-8124
(Factory Service)
Internet:
http://www.crownaudio.com