INSTALLATION & OPERATION MANUAL 10091 REV 0 (05/21)
PAGE
6
OF 16
Electric Power Tilt Skillets
I
NSTALLATION
WARNING
Before performing any maintenance disconnect the electrical power supply and place a tag at the disconnect
switch to indicate that you are working on the circuit.
WARNING
ELECTRICAL GROUNDING INSTRUCTIONS
Electrical and grounding connections must comply with the applicable portions of the National Electrical
Code and/or other local codes.
Electrical Connections
The wiring compartment is located behind the control panel. Refer to Service Connections in this manual.
1. Remove the wiring compartment cover and make electrical connections per the wiring diagram located inside the
control housing cover panel. (The braising pan must be grounded in accordance with requirements of the National
Electrical Code or applicable local codes.) See above warning. Connection from incoming lines must be waterproof.
2. Ground skillet to terminal provided in control housing. A wiring diagram is provided and is located inside the control
cover panel.
3. Replace wiring compartment cover.
Service
Connections
All internal wiring for the skillet is complete.
Make service connections as indicated on page 4 and electrical connections above.
If a faucet is provided, connect the water supplies and check for proper operation.
